Editing DC Furs DC28 Mask

=Environment Setup=
Getting the right environment setup for this was a huge pain. Needed Ubuntu 20.04 image, then install:
    sudo apt-get install autoconf automake autotools-dev curl python3 libmpc-dev libmpfr-dev libgmp-dev gawk build-essential bison flex texinfo gperf libtool patchutils bc zlib1g-dev libexpat-dev git
You will need to clone the following repos:
    git clone https://github.com/riscv-collab/riscv-gnu-toolchain.git
    git clone https://github.com/defconfurs/dcfurs-badge-dc28.git
Enter the RISCV folder and perform:
    ./configure --enable-multilib
    make
Enter the dcfurs badge folder and verify the following gives no errors:
    ./make.py build

=Ref=
* [https://github.com/riscv-collab/riscv-gnu-toolchain RISCV] toolchain
* [https://github.com/defconfurs/dcfurs-badge-dc28 Github] for software
[[Category: Badgelife]]